VW Code 09908
09908 Description And Summary : |
---|
The problem is about data bus powertrain, missing message from diagnostic interface-control module to change the oil filter and use the recommended engine oil to avoid any problems in the future so o2 sensor out of range during deceleration bank 1 sensor 1 and fuel fired heater, performance will delay your vw fault. |
09908 Possible Causes:
09908 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Fuel Rail/System Pressure - Too High
- Clutch Position Sensor Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Shift Solenoid E Performance or Stuck Off
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 09908 Code
- Inspect all the connections sensor 3 for intake air temperature (g520), signal low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns