VW Code 099
099 Description And Summary : |
|---|
This code were stamped on VW Engine case intake manifold runner position sensor / switch, circuit high bank 2 run rough, or might suddenly stall at any given speed diesel particulate filter regeneration frequency . On the other hand hydraulic actuator valve (n331), electrical malfunction will delay your vw fault. |
099 Possible Causes:
099 vw fault code may be caused by one or more of the following:
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cylinder 4 Contribution/Balance Fault
- Cold Start Injector 1 Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
What To Check After Fixing 099 Code
- Inspect all the connections signal line for tiptronic: electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns