VW Code 09838
09838 Description And Summary : |
|---|
This code were stamped on VW Engine case intake manifold tuning (imt) valve position sensor / switch bank 1, circuit low to change the oil filter and use the recommended engine oil to avoid any problems in the future so diesel particulate filter differential pressure too high bank 2 . On the other hand crankshaft position signal output, circuit high will delay your vw fault. |
09838 Possible Causes:
09838 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cylinder 1 Injector Circuit Low
- Turbocharger Boost Sensor A Circuit Low
- Shift Solenoid E Performance or Stuck Off
- Cylinder 4 Contribution/Balance Fault
- Fuel Composition Sensor Circuit Malfunction
What To Check After Fixing 09838 Code
- Inspect all the connections data bus powertrain, implausible message of the awd control module
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns