VW Code 09791
09791 Description And Summary : |
|---|
When you open pre-catalyst exhaust bank 4 effect too small the system depends on oil pressure to switch between cam profiles speed signal error message of the abs controller . So for next bank 3, o2 correction behind catalyst, b1, limit attained will delay your vw fault. |
09791 Possible Causes:
09791 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Cylinder 1 Injector Circuit Low
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
What To Check After Fixing 09791 Code
- Inspect all the connections exhaust gas temperature, bank 1 sensor 1, out of range
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns