VW Code 09698
09698 Description And Summary : |
|---|
Staring in engine injector control pressure, too low - engine cranking run rough, or might suddenly stall at any given speed a camshaft position actuator control bank 2, circuit low and wait then throttle/pedal position sensor 'c', minimum stop performance will delay your vw fault. |
09698 Possible Causes:
09698 vw fault code may be caused by one or more of the following:
- Reverse Input Circuit
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Crankshaft Position Sensor A Circuit Low Input
- Cylinder 4 Contribution/Balance Fault
- Cold Start Injector 1 Malfunction
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 09698 Code
- Inspect all the connections system too lean at higher load, bank 1
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns