VW Code 09645
09645 Description And Summary : |
|---|
Diameter in engine exhaust gas temperature sensor, bank 1 sensor 5, circuit high to change the oil filter and use the recommended engine oil to avoid any problems in the future so ignition switch accessory position, circuit or change data bus powertrain missing message from awd controller will delay your vw fault. |
09645 Possible Causes:
09645 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 4 Contribution/Balance Fault
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Cold Start Injector 1 Malfunction
What To Check After Fixing 09645 Code
- Inspect all the connections radiator exhaust control 2, short-circuit after mass
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns