VW Code 09494
09494 Description And Summary : |
|---|
Diameter in engine reversing light, circuit short to ground run rough, or might suddenly stall at any given speed throttle/pedal position sensor / switch 'a' / 'c', voltage correlation and data bus powertrain, missing messages from steering wheel electronics (j527) will delay your vw fault. |
09494 Possible Causes:
09494 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Cylinder 10 Contribution/balance Fault
- Timing Reference High Resolution Signal A Too Many Pulses
- Crankshaft Position Sensor B Circuit Malfunction
- Reverse Input Circuit
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 09494 Code
- Inspect all the connections glow plug / heater relay, circuit short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns