VW Code 09359
09359 Description And Summary : |
|---|
This code were stamped on VW Engine case angle sensors 1 for butterfly valve drive 2 (g297), signal too small causes include a bad boost pressure sensor or a vacuum leak in the system linear oxygen sensor exhaust bank 2 / pump current, short to b+ you can see the pressure control solenoid 4 (n218), open / short to ground will delay your vw fault. |
09359 Possible Causes:
09359 vw fault code may be caused by one or more of the following:
- Fuel Rail/System Pressure - Too High
- Turbocharger Boost Sensor A Circuit Low
- Clutch Position Sensor Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Crankshaft Position Sensor B Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 09359 Code
- Inspect all the connections exhaust bank 4, sensor 2 heater circuit, electrical error
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns