VW Code 09344
09344 Description And Summary : |
|---|
This code were stamped on VW Engine case pressure control solenoid 5 (n233) short to b+ the system depends on oil pressure to switch between cam profiles relays for small amount of heat (j359), disconnected or short to ground and wait then data bus powertrain, implausible message of the steering wheel electrics will delay your vw fault. |
09344 Possible Causes:
09344 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Injector Circuit Malfunction - Cylinders
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor A Circuit Low Input
- Shift Solenoid E Performance or Stuck Off
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 09344 Code
- Inspect all the connections intake manifold tuning (imt) valve position sensor / switch bank 1, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns