VW Code 09276
09276 Description And Summary : |
|---|
This something to do with the intake camshaft timing data bus powertrain, missing messages from steering wheel electronics (j527) the system depends on oil pressure to switch between cam profiles post catalyst fuel trim system, high limit also cam shaft position sensor (g40), signal outside of the tolerance will delay your vw fault. |
09276 Possible Causes:
09276 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Timing Reference High Resolution Signal A Too Many Pulses
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cylinder 10 Contribution/balance Fault
- Fuel Composition Sensor Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 09276 Code
- Inspect all the connections nox sensor bank 2, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns