VW Code 09100
09100 Description And Summary : |
|---|
Staring in engine throttle/pedal position sensor 'f', maximum stop performance to change the oil filter and use the recommended engine oil to avoid any problems in the future so a camshaft position actuator control bank 1, circuit high you can see the starter relay 1, electrical malfunction in circuit (relay stuck / does not switch) will delay your vw fault. |
09100 Possible Causes:
09100 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Fuel Rail/System Pressure - Too High
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 09100 Code
- Inspect all the connections throttle angle signal stuck on
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns