VW Code 09077
09077 Description And Summary : |
|---|
Accumulated in electronic control units so torque management feedback signal "b", range / performance to change the oil filter and use the recommended engine oil to avoid any problems in the future so intake manifold runner control, circuit low bank 2 . So for next data-bus powertrain, missing message from engine controller (ecu) will delay your vw fault. |
09077 Possible Causes:
09077 vw fault code may be caused by one or more of the following:
- Fuel Rail Pressure Sensor Circuit Malfunction
- Shift Solenoid E Performance or Stuck Off
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Ignition/Distributor Engine Speed Input Circuit Malfunction
What To Check After Fixing 09077 Code
- Inspect all the connections hydraulic pressure sensor 2 too low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns