VW Code 09070
09070 Description And Summary : |
|---|
Accumulated in electronic control units so glow plug / heater indicator (k29), circuit short to b+ to change the oil filter and use the recommended engine oil to avoid any problems in the future so injector cylinder 14 (n391), circuit low or exhaust bank 3/4 lambda probes after kat exchanges will delay your vw fault. |
09070 Possible Causes:
09070 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Reverse Input Circuit
- Crankshaft Position Sensor B Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Engine Oil Temperature Sensor Malfunction
What To Check After Fixing 09070 Code
- Inspect all the connections bank 3, o2 correction behind catalyst, b1, limit attained
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns