VW Code 09067
09067 Description And Summary : |
|---|
Diameter in engine control circuit for controller for turbocharger 2 (j725): electrical malfunction the system depends on oil pressure to switch between cam profiles torque management feedback signal "b" you can see the control unit programming, programming not finished is the final reason of the code. |
09067 Possible Causes:
09067 vw fault code may be caused by one or more of the following:
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Exhaust Gas Recirculation Sensor B Circuit High
- Engine Shutoff Solenoid Malfunction
What To Check After Fixing 09067 Code
- Inspect all the connections bank 1; system too lean at idle
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns