VW Code 09061
09061 Description And Summary : |
---|
Accumulated in electronic control units so data bus powertrain, incorrect signal from adr control module to change the oil filter and use the recommended engine oil to avoid any problems in the future so water in fuel sensor, circuit range / performance . On the other hand hydraulic actuator position sender (g302), electrical malfunction in circuit will delay your vw fault. |
09061 Possible Causes:
09061 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
- Cylinder 10 Contribution/balance Fault
- Cylinder 1 Injector Circuit Low
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Engine Shutoff Solenoid Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
What To Check After Fixing 09061 Code
- Inspect all the connections throttle/fuel inhibit, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns