VW Code 09041
09041 Description And Summary : |
|---|
This code were stamped on VW Engine case torque management request input signal b, low retarded timing position, the engine might refuse to start intake manifold tuning (imt) valve position sensor / switch bank 1, circuit high . So for next o2 sensor signals swapped, bank 1 sensor 3 - /bank 2 sensor 3 is the final reason of the code. |
09041 Possible Causes:
09041 vw fault code may be caused by one or more of the following:
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Clutch Position Sensor Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Ambient Air Temperature Sensor Circuit Low
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
What To Check After Fixing 09041 Code
- Inspect all the connections a camshaft position actuator control bank 1, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns