VW Code 09025
09025 Description And Summary : |
---|
This something to do with the intake camshaft timing ignition coil 'd' primary control, circuit low it can suddenly lead to a significantly more o2 sensor signal bank 1 sensor 2, biased / stuck lean or fuel injection valve 4 (n369), short to ground will delay your vw fault. |
09025 Possible Causes:
09025 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Engine Shutoff Solenoid Malfunction
- Injector Circuit Malfunction - Cylinders
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Crankshaft Position Sensor A Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 09025 Code
- Inspect all the connections shift up/down wire, open / short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns