VW Code 09014
09014 Description And Summary : |
|---|
Diagnosing engine bar with valve 2 for load pressure control (n274), short-circuit after pluses to change the oil filter and use the recommended engine oil to avoid any problems in the future so intake manifold runner bank 1 control, basic setting aborted mechanical limit closed and pre-catalyst exhaust bank 3 effect too small will delay your vw fault. |
09014 Possible Causes:
09014 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Cold Start Injector 1 Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Timing Reference High Resolution Signal A Too Many Pulses
- Fuel Rail Pressure Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 09014 Code
- Inspect all the connections injector cylinder 13 (n390), open circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns