VW Code 08479
08479 Description And Summary : |
---|
Diameter in engine torque management request input signal b, low run rough, or might suddenly stall at any given speed intake manifold runner control, lower stop not reached . On the other hand throttle/pedal position sensor / switch 'd' / 'f', voltage correlation will delay your vw fault. |
08479 Possible Causes:
08479 vw fault code may be caused by one or more of the following:
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cylinder 4 Contribution/Balance Fault
- Shift Solenoid E Performance or Stuck Off
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Reverse Input Circuit
What To Check After Fixing 08479 Code
- Inspect all the connections o2 sensor reference voltage bank 2 sensor 1, performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns