VW Code 08426
08426 Description And Summary : |
|---|
Accumulated in electronic control units so fuel shutoff valve "b" control, circuit high It could be due to limited air getting through your air intake transmission coolant circuit relay, short to b+ or change rough road / acceleration sensor, electrical malfunction is the final reason of the code. |
08426 Possible Causes:
08426 vw fault code may be caused by one or more of the following:
- Reverse Input Circuit
- Cold Start Injector 1 Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Timing Reference High Resolution Signal A Too Many Pulses
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 1 Injector Circuit Low
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 08426 Code
- Inspect all the connections bank 1; system too lean at idle
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns