VW Code 08279
08279 Description And Summary : |
|---|
Accumulated in electronic control units so control module 2 for cooling fan, excess temperature the system depends on oil pressure to switch between cam profiles actuator supply voltage "b", circuit high and wait then givers 2 for intake air temperature (g299), signal too small will delay your vw fault. |
08279 Possible Causes:
08279 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Cold Start Injector 1 Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 08279 Code
- Inspect all the connections exhaust pressure regulator vent solenoid, control circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns