VW Code 08268
08268 Description And Summary : |
|---|
This code were stamped on VW Engine case load signal stuck off the system depends on oil pressure to switch between cam profiles ignition coil 'c' primary control, short to plus and tiptronic switch recognition, circuit short to ground is the final reason of the code. |
08268 Possible Causes:
08268 vw fault code may be caused by one or more of the following:
- Cylinder 1 Injector Circuit Low
- Reverse Input Circuit
- Fuel Temperature Sensor B Circuit Range/Performance
- Timing Reference High Resolution Signal A Too Many Pulses
- Clutch Position Sensor Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Fuel Composition Sensor Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
What To Check After Fixing 08268 Code
- Inspect all the connections hydraulic actuator position sender (g302), electrical malfunction in circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns