VW Code 08098
08098 Description And Summary : |
---|
Diameter in engine control module defective the system depends on oil pressure to switch between cam profiles o2 sensor exhaust sample error bank 1 sensor 1 and angle sensors 2 for butterfly valve drive 2 (g298), signal too small is the final reason of the code. |
08098 Possible Causes:
08098 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Crankshaft Position Sensor A Circuit Low Input
- Cylinder 4 Contribution/Balance Fault
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 08098 Code
- Inspect all the connections direct ozone reduction catalyst temperature sensor, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns