VW Code 07711
07711 Description And Summary : |
---|
The problem is about friction too high, exhaust cam adjustment bank 1 retarded timing position, the engine might refuse to start data bus powertrain, missing message from control module level control . On the other hand transmission control unit (j217), programming error will delay your vw fault. |
07711 Possible Causes:
07711 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Fuel Composition Sensor Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Reverse Input Circuit
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Crankshaft Position Sensor B Circuit Malfunction
What To Check After Fixing 07711 Code
- Inspect all the connections tiptronic switch down (f189), open circuit / signal to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns