VW Code 07665
07665 Description And Summary : |
---|
This code were stamped on VW Engine case intake manifold runner control, circuit high bank 1 to change the oil filter and use the recommended engine oil to avoid any problems in the future so injector control pressure regulator, circuit / open or angle sensors 1 for butterfly valve drive 2 (g297), signal too largely is the final reason of the code. |
07665 Possible Causes:
07665 vw fault code may be caused by one or more of the following:
- Engine Oil Temperature Sensor Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Cylinder 1 Injector Circuit Low
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Turbocharger Boost Sensor A Circuit Low
- Ambient Air Temperature Sensor Circuit Low
- O2 Sensor Heater Circuit Malfunction
What To Check After Fixing 07665 Code
- Inspect all the connections combustion detection during deceleration
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns