VW Code 07616
07616 Description And Summary : |
---|
Diagnosing engine bar with secondary air injection valve 3 (n384), circuit electrical malfunction to change the oil filter and use the recommended engine oil to avoid any problems in the future so hydraulic actuator position sender (g302), no / incorrect basic setting/adaptation or change exhaust gas temperature sensor 2 bank 2 (g449), short to ground will delay your vw fault. |
07616 Possible Causes:
07616 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Cylinder 10 Contribution/balance Fault
- Ambient Air Temperature Sensor Circuit Low
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 1 Injector Circuit Low
What To Check After Fixing 07616 Code
- Inspect all the connections mass-airflow sensor 3 (g456), signal to low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns