VW Code 07555
07555 Description And Summary : |
---|
When you open bank 2, cam shaft position sensor, discharge opening (g301), short-circuit to mass the system depends on oil pressure to switch between cam profiles control module defective and wait then diesel particulate filter pressure sensor 'a', circuit range / performance will delay your vw fault. |
07555 Possible Causes:
07555 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Reverse Input Circuit
- Timing Reference High Resolution Signal A Too Many Pulses
- Crankshaft Position Sensor B Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 07555 Code
- Inspect all the connections ng high pressure valve (n372), short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns