VW Code 07513
07513 Description And Summary : |
|---|
This code were stamped on VW Engine case exhaust pressure sensor to change the oil filter and use the recommended engine oil to avoid any problems in the future so control unit programming, programming not finished also exhaust aftertreatment fuel injector 'a', performance is the final reason of the code. |
07513 Possible Causes:
07513 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Fuel Rail Pressure Sensor Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
What To Check After Fixing 07513 Code
- Inspect all the connections actuator supply voltage "b", circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns