VW Code 07509
07509 Description And Summary : |
|---|
Diagnosing engine bar with change-over valve for intake manifold flap 2, high the system depends on oil pressure to switch between cam profiles angle sensors 1 for butterfly valve drive 2 (g297), signal too largely . So for next crankshaft position signal output, circuit low will delay your vw fault. |
07509 Possible Causes:
07509 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 07509 Code
- Inspect all the connections a/c refrigerant distribution valve control, circuit / open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns