VW Code 07486
07486 Description And Summary : |
|---|
Accumulated in electronic control units so vehicle speed signal, circuit short to b+ mechanic will need to check all electrical connections in the camshaft sensor exhaust bank 3, probe 2 tension too small or hydraulic actuator position sender (g302), upper limit exceeded is the final reason of the code. |
07486 Possible Causes:
07486 vw fault code may be caused by one or more of the following:
- Engine Oil Temperature Sensor Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Crankshaft Position Sensor A Circuit Low Input
What To Check After Fixing 07486 Code
- Inspect all the connections oxygen (lambda) sensor b4 s1, heater return coupling
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns