VW Code 07485
07485 Description And Summary : |
|---|
Accumulated in electronic control units so exhaust gas temperature sensor 2 bank 1 (g448), range / performance the system depends on oil pressure to switch between cam profiles kick down switch malfunction you can see the data bus powertrain, implausible message from control module fuel pump is the final reason of the code. |
07485 Possible Causes:
07485 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Fuel Temperature Sensor B Circuit Range/Performance
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Crankshaft Position Sensor B Circuit Malfunction
- Ambient Air Temperature Sensor Circuit Low
- O2 Sensor Heater Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 07485 Code
- Inspect all the connections cam shaft position sensor (g40), signal outside of the tolerance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns