VW Code 07436
07436 Description And Summary : |
|---|
Staring in engine starter relay 1, electrical malfunction in circuit (relay stuck / does not switch) the system depends on oil pressure to switch between cam profiles linear oxygen sensor exhaust bank 4, compensation wire pump current, open circuit or change supply voltage for fuel injector group a, open circuit will delay your vw fault. |
07436 Possible Causes:
07436 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Crankshaft Position Sensor A Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Timing Reference High Resolution Signal A Too Many Pulses
- Fuel Rail/System Pressure - Too High
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
What To Check After Fixing 07436 Code
- Inspect all the connections throttle actuator control module, internal circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns