VW Code 07285
07285 Description And Summary : |
|---|
This something to do with the intake camshaft timing hydraulic actuator position sender (g302), upper limit exceeded the system depends on oil pressure to switch between cam profiles wheel speed signal 1, range / performance and wait then throttle actuator control module, internal circuit is the final reason of the code. |
07285 Possible Causes:
07285 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 10 Contribution/balance Fault
- Fuel Rail/System Pressure - Too High
- Cylinder 1 Injector Circuit Low
- Exhaust Gas Recirculation Sensor B Circuit High
What To Check After Fixing 07285 Code
- Inspect all the connections a/c request b, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns