VW Code 07016
07016 Description And Summary : |
|---|
When you open change-over valve for intake manifold flap 2, performance or stuck off to change the oil filter and use the recommended engine oil to avoid any problems in the future so post catalyst fuel trim system, high limit you can see the load signal, error message from ecu is the final reason of the code. |
07016 Possible Causes:
07016 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Glow Plug/Heater Circuit 'A' Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Crankshaft Position Sensor A Circuit Low Input
- Exhaust Gas Recirculation Sensor B Circuit High
What To Check After Fixing 07016 Code
- Inspect all the connections radiator exhaust control 1, short-circuit after pluses
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns