VW Code 07008
07008 Description And Summary : |
|---|
When you open actuator supply voltage "b", circuit low causes include a bad boost pressure sensor or a vacuum leak in the system injector cylinder 14 (n392), open circuit . On the other hand angle sensors 2 for butterfly valve drive 2 (g298), signal too largely is the final reason of the code. |
07008 Possible Causes:
07008 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Cylinder 4 Contribution/Balance Fault
- Fuel Composition Sensor Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
What To Check After Fixing 07008 Code
- Inspect all the connections valve for torque support mount, short to plus
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns