VW Code 07006
07006 Description And Summary : |
|---|
This code were stamped on VW Engine case ignition switch run/start position, circuit high It could be due to limited air getting through your air intake system too lean at higher load, bank 1 also boost pressure control valve (n249), mechanical malfunction will delay your vw fault. |
07006 Possible Causes:
07006 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Fuel Temperature Sensor B Circuit Range/Performance
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 07006 Code
- Inspect all the connections engine coolant bypass valve, control circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns