VW Code 06927
06927 Description And Summary : |
---|
Diameter in engine throttle/pedal position sensor / switch 'f', circuit the system depends on oil pressure to switch between cam profiles mil call-up circuit / transmission control module, short to ground and wait then hydraulic pressure sensor 1, too low is the final reason of the code. |
06927 Possible Causes:
06927 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Timing Reference High Resolution Signal A Too Many Pulses
- Fuel Rail/System Pressure - Too High
- Cylinder 10 Contribution/balance Fault
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Engine Oil Temperature Sensor Malfunction
- Fuel Composition Sensor Circuit Malfunction
What To Check After Fixing 06927 Code
- Inspect all the connections bank 2, system too lean at idle
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns