VW Code 06730
06730 Description And Summary : |
|---|
This code were stamped on VW Engine case intake manifold runner position sensor / switch, circuit bank 1 to change the oil filter and use the recommended engine oil to avoid any problems in the future so secondary air injection pump-c-relay (j704), circuit short to ground or change cylinder 2 above knock threshold will delay your vw fault. |
06730 Possible Causes:
06730 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor B Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Cold Start Injector 1 Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Fuel Rail/System Pressure - Too High
What To Check After Fixing 06730 Code
- Inspect all the connections fuel pump "b" control, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns