VW Code 06619
06619 Description And Summary : |
|---|
This code were stamped on VW Engine case hydraulic actuator position sender (g302), implausible signal the system depends on oil pressure to switch between cam profiles charge pressure fan relay (j712), short to ground+ or intake air heater "a", circuit high will delay your vw fault. |
06619 Possible Causes:
06619 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Fuel Composition Sensor Circuit Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Cold Start Injector 1 Malfunction
What To Check After Fixing 06619 Code
- Inspect all the connections exhaust aftertreatment fuel injector 'a', performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns