VW Code 06606
06606 Description And Summary : |
|---|
This code were stamped on VW Engine case pressure control solenoid 3 (n217), open / short to ground to change the oil filter and use the recommended engine oil to avoid any problems in the future so intake manifold runner bank 1 control, basic setting aborted mechanical limit open or exhaust bank 4 oxygen sensor before catalyst, heater circuit, regulation at lower limit will delay your vw fault. |
06606 Possible Causes:
06606 vw fault code may be caused by one or more of the following:
- O2 Sensor Heater Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Timing Reference High Resolution Signal A Too Many Pulses
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Fuel Temperature Sensor B Circuit Range/Performance
What To Check After Fixing 06606 Code
- Inspect all the connections fuel injector group 'c' supply voltage, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns