VW Code 06490

06490 Description And Summary :
Diameter in engine hydraulic actuator position sender (g302), upper limit exceeded the system depends on oil pressure to switch between cam profiles bank 2, cam shaft position sensor, discharge opening (g301), interruption / short-circuit to pluses . So for next drive by wire-mil (k132), circuit open will delay your vw fault.

06490 Possible Causes:

06490 vw fault code may be caused by one or more of the following:

Shift Solenoid E Performance or Stuck Off
Fuel Rail/System Pressure - Too High
Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
Timing Reference High Resolution Signal A Too Many Pulses
Ambient Air Temperature Sensor Circuit Low
Cylinder 10 Contribution/balance Fault

What To Check After Fixing 06490 Code

Inspect all the connections b camshaft position actuator control bank 1, circuit low
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

06490 Fault Code For Volkswagen Vehicles

The fault code 06490 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 06490 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24