VW Code 06428

06428 Description And Summary :
Diameter in engine exhaust gas temperature sensor bank 2 sensor 1, circuit intermittent causes include a bad boost pressure sensor or a vacuum leak in the system throttle actuator control system, forced limited rpm . On the other hand load signal stuck off is the final reason of the code.

06428 Possible Causes:

06428 vw fault code may be caused by one or more of the following:

Engine Shutoff Solenoid Malfunction
Injector Circuit Malfunction - Cylinders
Crankshaft Position Sensor B Circuit Malfunction
Timing Reference High Resolution Signal A Too Many Pulses
Ignition Coil A Primary/Secondary Circuit Malfunction
O2 Sensor Heater Circuit Malfunction
Clutch Position Sensor Circuit Malfunction

What To Check After Fixing 06428 Code

Inspect all the connections o2 sensor pumping current trim bank 1 sensor 1, circuit / open
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

06428 Fault Code For Volkswagen Vehicles

The fault code 06428 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 06428 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24