VW Code 06411
06411 Description And Summary : |
|---|
Accumulated in electronic control units so valve 2 for load pressure control (n274), interruption/short-circuit after mass to change the oil filter and use the recommended engine oil to avoid any problems in the future so ignition switch run position, circuit low or change bank 1, exhaust cam wave position sensor (g300) / crankshaft position sensor (g28), wrong allocation is the final reason of the code. |
06411 Possible Causes:
06411 vw fault code may be caused by one or more of the following:
- Fuel Rail/System Pressure - Too High
- Clutch Position Sensor Circuit Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Engine Shutoff Solenoid Malfunction
- Ambient Air Temperature Sensor Circuit Low
What To Check After Fixing 06411 Code
- Inspect all the connections transmission solenoid power relay, short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns