VW Code 06358
06358 Description And Summary : |
---|
This code were stamped on VW Engine case intake manifold runner control: open stop outside of valid range It could be due to limited air getting through your air intake throttle actuator control system, high air flow detected or torque management request input signal b, high will delay your vw fault. |
06358 Possible Causes:
06358 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Glow Plug/Heater Circuit 'A' Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
What To Check After Fixing 06358 Code
- Inspect all the connections relay for exhaust cooling agent (n313), short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns