VW Code 06262
06262 Description And Summary : |
|---|
The problem is about actuator supply voltage 'c', circuit high the system depends on oil pressure to switch between cam profiles internal control module, malfunction . On the other hand relays for large amount of heat (j360), disconnected or short to ground is the final reason of the code. |
06262 Possible Causes:
06262 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Engine Shutoff Solenoid Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Crankshaft Position Sensor A Circuit Low Input
- Fuel Rail Pressure Sensor Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 06262 Code
- Inspect all the connections nox sensor heater control bank 1, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns