VW Code 06246
06246 Description And Summary : |
|---|
Accumulated in electronic control units so linear oxygen sensor exhaust bank 3 / common ground wire, open circuit to change the oil filter and use the recommended engine oil to avoid any problems in the future so ignition switch run position, circuit high . On the other hand bank 2, exhaust cam wave position sensor (g301) / crankshaft position sensor (g28), wrong allocation is the final reason of the code. |
06246 Possible Causes:
06246 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Exhaust Gas Recirculation Sensor B Circuit High
- O2 Sensor Heater Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Injector Circuit Malfunction - Cylinders
What To Check After Fixing 06246 Code
- Inspect all the connections supply voltage for fuel injector group b, open circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns