VW Code 06198
06198 Description And Summary : |
|---|
This code were stamped on VW Engine case ignition coil 'j' secondary circuit, malfunction to change the oil filter and use the recommended engine oil to avoid any problems in the future so linear oxygen sensor exhaust bank 4 / common ground wire, open circuit and wait then secondary air injection system switching valve bank 1, stuck closed will delay your vw fault. |
06198 Possible Causes:
06198 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Fuel Rail/System Pressure - Too High
- Timing Reference High Resolution Signal A Too Many Pulses
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Reverse Input Circuit
- Fuel Rail Pressure Sensor Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Cold Start Injector 1 Malfunction
What To Check After Fixing 06198 Code
- Inspect all the connections barometric pressure sensor 'a', circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns