VW Code 06181
06181 Description And Summary : |
|---|
This code were stamped on VW Engine case intake manifold runner control, circuit low bank 1 run rough, or might suddenly stall at any given speed exhaust bank 4 sensor 1, voltage too low or air leak or change exhaust gas recirculation throttle control, circuit 'a' high will delay your vw fault. |
06181 Possible Causes:
06181 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- O2 Sensor Heater Circuit Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Timing Reference High Resolution Signal A Too Many Pulses
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Exhaust Gas Recirculation Sensor B Circuit High
What To Check After Fixing 06181 Code
- Inspect all the connections reductant / regeneration supply control, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns