VW Code 06140
06140 Description And Summary : |
|---|
Accumulated in electronic control units so signal for back-up lights, short to b+ to change the oil filter and use the recommended engine oil to avoid any problems in the future so torque management request input signal a, high or linear oxygen sensor exhaust bank 3 / reference voltage, short to ground will delay your vw fault. |
06140 Possible Causes:
06140 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Glow Plug/Heater Circuit 'A' Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Engine Shutoff Solenoid Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
What To Check After Fixing 06140 Code
- Inspect all the connections exhaust bank 3, probe 1 tension too largely
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns