VW Code 06100
06100 Description And Summary : |
|---|
The problem is about ecm/pcm power relay sense, circuit range / performance causes include a bad boost pressure sensor or a vacuum leak in the system ignition coil 'f' secondary circuit, malfunction and wait then glow plug / heater relay, circuit open / short to ground will delay your vw fault. |
06100 Possible Causes:
06100 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Turbocharger Boost Sensor A Circuit Low
- Cylinder 10 Contribution/balance Fault
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 06100 Code
- Inspect all the connections exhaust bank 3, probe 2 tension too small
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns